24 Tatula Full Bearing Tune Part 4: Spool Bearing Diameter Reduction
Now for the assembly. Regarding the spool bearing on the cap side, it is a 1030 bearing, which becomes a dual-bearing setup consisting of 1060 + 630 bearings. While the original bearing had a 4mm width, the outer diameter becomes 3mm and the inner bearing becomes 2.5mm. Even with the retaining pin inserted, both the […]
24 Tatula Full Bearing Tune: Adding Two Bearings to the Handle
The handle only has one bearing at the tip, and the base uses a resin bushing as shown in the photo. We will replace this with a 740 ZZ bearing. Use a thin hex wrench to hook and pull out the cap, then remove the screw, which has plenty of Loctite on it. I thought […]
24 Tatula Full Bearing Tune Part 2: Adding Bearings to the Level Winder
Since this is already my third time doing this, I'm used to it and can take it apart quickly. I always tend to forget the assembly order, so I carefully lay out the parts in a case from right to left in the exact order I remove them. To replace the bearings in the level […]