Tying Leaders to Braided Line with the FG Knot

English

Connecting my leader to the braided line using an FG knot.

If you don't retie once in a while, both the braid and leader get worn down, so I re-rigged two of my bass setups today.

I just use my rod and hands. First, cut off and discard a few meters of braid along with the old leader—ideally, cutting back as much line as you usually cast is best. Pull some braid from the rod, wrap the end around your thumb, and pull it taut to keep tension. In the photo, it's also wrapped around my index finger, but that's not strictly necessary; I just do it out of habit.

Hold the leader in your left hand and alternate weaving it left and right into an FG knot. (I had to let go with my left hand just to snap the picture!)

Pinch the opposite side of the braid between the index and middle fingers of your right hand like this, crisscrossing it alternately 10 to 15 times. It's a bit hard to explain in words, but once you start wrapping, you'll get the feel for it.

Do about five half-hitches over both the braid and the leader, then lightly singe the leader tag end with a lighter to form a small ball so it doesn't slip through. After that, finish with about five more half-hitches over just the braid.

Once that's wrapped—what's it called, a double half-hitch?—lock it in, trim the braid while pulling it tight under tension, and melt the tip with a lighter too. This one isn't to stop slipping, but rather to keep the braid from fraying.

Some people find braid difficult to cut and buy specialized PE line scissors, but you really don't need them. As long as you keep the line tight under tension, even the dullest, cheapest pair of scissors will slice right through it. If braid were truly that impossible to cut, we'd never have to worry about break-offs while fishing!

And that's it! Even when you're out on the water, you can get this done in about three minutes.

Leave a Reply