DIY Prop Popper: Building Production Model #1

English

Next up is building Unit #1! Since Unit #0 was just a prototype to test the build process, this is officially the first true production model. And because it's Unit #1, it belongs to my eldest son, Ichi. As with the previous build, I’m sticking with Daiso's 100-yen UV resin.

He requested pink—he probably imagined a bold, hot sneaker pink—but I personally wanted to try clear pink resin, so that's what I went with.

Fresh out of the mold! It weighs 12g, so I figured adding a 5.5g pachinko ball as the internal weight would be just right, but...

Here it is test-fitted with a pachinko ball I picked up off the street. It was pretty clear at this point, but the inside was sticky, and spraying it with parts cleaner turned it a cloudy white.

Next, I sanded and polished the surface. I reinforced the eyelet insertion points with extra UV resin. I also made tiny UV resin plates to use as dividing walls and poured resin around them. The weight is set up so it can roll freely around the center.

I held the two halves together with rubber bands, poured UV resin along the seam, and cured it under the UV light. The mouth didn't turn out quite right, but no problem—I can just cast the mouth separately from the mold and glue it on. UV resin really is incredible.

As for the seam... because I used clear UV resin, there's a visible transparent line running through it. The replicated mouth attached nicely, too.

And with that, Production Prototype #1 is finished! The edges on the face softened up a bit, giving it a rounder look.

What do you think?

I took it for a test swim. It seemed great at the time... but later, when I cast it at Kuboshiro Dam, it sank straight to the bottom...

Rattle sound from the internal weight.

Since it sank, I checked the weight of Unit #0. Fully rigged with the prop and hooks, it was 19g.

Unit #1, on the other hand, was 22g. Yeah... that pachinko ball was definitely way too heavy.

By the way, the hooks and prop weigh 3g combined.

Nothing else to do but slice the belly open and swap out the weight. Time to saw away.

Using a drill as well, I popped the belly right open. Then, I replaced the ball with a 3g (size 0.8) lead fishing sinker.

Double-checking the buoyancy. The red lure next to it is Unit #2. In the glass, the hooks aren't touching the bottom, so we're good to go!

Leave a Reply