Installing a Honda Throttle on My Motorized Kayak
I'm going to install the Honda throttle I picked up after seeing it at Hansman.

I grabbed a random piece of angle iron lying around, cut it to the right length, and bent it to use as a mount.

It fits and looks pretty good.
By the way, the cut on my left index finger happened while camping with my son using a saw—it has nothing to do with brushcutters or modifying equipment!

While I'm at it, I'm swapping out the kill switch for a cool, highly visible red universal switch. I grabbed this at Hansman too. I've been going there constantly lately. I'm going to solder it using the stash of 2-pole wiring sockets I have at home.

Since it fits nicely, I'll just connect the other side to the original wire however works. These just need to make contact, so the pairing doesn't matter much. That said, a bad connection means the engine won't shut off, which is a disaster—so make sure to solder it properly!

Looking at the throttle cable on the handlebar side, it's pretty frayed. The other side had a strand snapped too, so I ended up buying a replacement later. Oh, and a plastic pipe I bought for a totally different project turned out to be the exact right size! I'll use it as a cover.
And since the wire felt a little too long, I made a makeshift stopper using a 2mm inner diameter aluminum pipe I had bought for Mini 4WD cars.

Turns out I didn't need it after all, so I ended up not using it in the final setup.

I attached the plastic pipe like this. While this made it harder to slip off, the outer casing of the wire would still occasionally slide down and keep the throttle from returning. Time to fix that issue.

I tapped the pipe to cut female threads, secured it with a set screw, and tightened it down.

The throttle snap-back improved quite a bit, but still wasn't quite right. The angle between the engine's throttle component and the wire—something that's been bothering me for a while—was a bit harsh. I decided to bend it into a more natural alignment.

I used double pliers and brute force. Since the base is plastic, it's probably better to take it off first, but hey, I managed to do it right on the unit. It got a great angle now.

And with that, it's finished! The brushcutter shaft was getting in the way, so I mounted it onto a shovel handle instead.
Check out the video below.
Moves nicely, right? But since I was still worried about the frayed wire, I went ahead and bought a brand-new one shortly after.
Also, after tinkering with this throttle in various ways, I finally figured out how it's meant to be used. It features two adjustment screws and two levers. Adjusting the top screw lets you change the travel distance when you squeeze the larger lever, allowing you to set your maximum power limit—handy for locking in your go-to cruising speed while clearing brush. But that's not all! If you turn the screw located between the smaller and larger levers, the smaller lever moves further away. What's this for? Turns out, when you squeeze the smaller lever, you get an additional range of travel based on how much you turned that screw. It even has an extra spring that gives it a nice, firm resistance. Basically, you can fine-tune your squeezing stroke in two stages. Pretty neat, right? When you're cruising normally versus cutting through thicker wood, you can push past into that max-power lever. After actually taking it out to test-cut some grass and tweaking it along the way, I've really come to appreciate how well-designed this throttle is.


