Installing the ATOTO S8 Head Unit Part 3: Temporary Setup & Power Test

English

Continuing our series on installing the ATOTO S8 head unit! In this post, we'll cover everything from removing the factory audio system to trial-and-error placement of the ATOTO unit.

Here is the starting point for this series.

Temporary Setup

Time to strip away the interior panels. I skipped taking photos of the process, but you can remove the front-left pillar, the lower cover in front of the passenger seat, and the central air vent shown here. I used an interior trim removal tool for the first time, but honestly, you don't even need one—just pull and pop everything off with confidence!

The audio unit slides right out once you remove this single bolt. It seems to be held in place by plastic clips, too. Assembly efficiency must be off the charts.

The entire plastic base supporting the audio panel comes out as one piece. The main unit is tucked deep inside; it's a full 1DIN size, which feels way too huge for just a basic radio. I wondered if it housed some ECU-like module or other hidden functions, but apparently, there's nothing in there at all. Removing it causes zero issues. The front display unit alone should be plenty, so why is this thing so ridiculously oversized?!

Next, unplug the connectors. There's a surprising number of wires—do we really need this many? Maybe because the wiring harness is shared with navigation models?

Plug the custom wiring harness I prepared in advance into the connectors. At this point, I still hadn't acquired the FM antenna adapter.

I popped the unit in temporarily (literally just resting it there), put the air vent cover back on, and fired up the engine. It booted up without a single issue! Even just sitting there loosely, it already looks like a great fit.

How it looks from the outside. Hmm, not bad at all, right?
From here, it's time for some trial and error on how to securely mount it for the final installation.

Stay tuned for the next article!

Leave a Reply