Installing the ATOTO S8 Head Unit Part 2: Wiring & Modifications

English

This article covers the wiring modification process.


Check out the previous article here.

Here is a photo of the accessories from the last post.

We'll be modifying the universal harness included in the kit. One of the harnesses (on the left) is for Toyota. If it fit out of the box, life would be easy and we could just plug and play. While I suppose I could just cut the coupler off that one, the other harness (on the right) is a generic type without a car-side coupler, making it much easier to work with. Since my car is a Mazda, I'll be using this one.

I also picked up a separate 24-pin Mazda audio harness. There are a few different types depending on whether your car is older or newer, and it's always super stressful wondering if you've ordered the right one! I grabbed this one off Amazon—it's the correct model for the ND Roadster.

Just like the old days, it uses bullet connectors. I need to attach matching bullet connectors to the end of the navigation unit's harness to fit this. Tasks like this are honestly a bit too easy and not all that fun anymore. I'd much rather be tinkering with the engine or turning wrenches—that's where the real fun is. I guess I'm just not cut out to be a hardware guy, even though my day job is in software.

Maybe as a cost-cutting measure, none of the wires on this harness are labeled. Realizing that troubleshooting a wiring mess after installing it in the car would be a nightmare, and remembering we had a LabelWriter at home for the kids, I decided it was time to put it to use. I carefully printed and attached labels for every single signal name. I definitely wouldn't have been this meticulous when I was younger—I guess I'm getting old. Having everything labeled should come in handy if I ever want to tap into unused wires for future mods.

The ATOTO-side wiring looks like this. It comes with proper protective covers to prevent short circuits. I stripped the ends and started attaching bullet connectors. Where did I even get these connectors? Leftovers from when I worked on my R32 20 years ago, or maybe my S15? Glad I never threw them out! One of the wires is labeled "Steering Wheel Key," which is presumably for controlling volume and other functions from the steering wheel. But my Roadster doesn't have steering wheel controls—and since it's a sports car, I'm not adding them either!

Back in the day, I used to get by with just pliers, but since I've been doing a lot of electronics DIY lately, I bought a proper crimping tool. Stripping the insulation is a breeze, but crimping is still tricky.

Accessory power (12V) is the kind that turns on when the ignition is engaged. Since I frequently use this power source whenever I add new electronic gadgets, and because I'll be routing various rear-camera signals, I set up two bullet connectors to allow for future expansion. I think I ended up attaching a 4-way splitter further down the line.

I have wires in several different colors, but I ran out of orange, so I had to make the double bullet connector for the accessory power (12V) using a yellow wire instead. Since I wanted the colors to match, I painted the mismatched wire using model paint. One of the perks of building plastic models!

And here it is. This wire looks a bit thick, but hey, it's for power, so a thicker gauge is totally fine.

Wiring is now complete, including provisional setups so I can test the camera. Next up: testing and setup right here in the room, followed by the plug-and-play installation in the car.

Is this the FM radio antenna coupler...? There is no way I can DIY this. It looks kind of like a coaxial plug. Cutting it off wouldn't be completely impossible, but coaxial cables have an outer shield, making them pretty delicate. I should probably just buy an OEM part.

Up next will likely be removing the factory audio system and prepping for the ATOTO installation.

Leave a Reply